You must disable the immobilizer or override the system to unlock your Toyota from anti-theft mode. Use the car key to unlock the door and leave it there for 30 seconds to accomplish this. Try starting the engine and leaving the key in the ignition for ten to fifteen minutes.
General process is to find a clean "virgin" dump for the EEPROM, and then write that to your EEPROM (inside the ECM) and then don't plug the immobilizer harness back in to the ECU so it stays in programming mode forever. You could also tape a chip key to ignition lock cylinder, that is how a lot of remote start installers do it. D When the correct key is inserted and turned in the ignition, the immobilizer system allows the engine to start. If an unauthorized key or an attempt to hot-wire the vehicle is detected, the immobilizer system prevents the engine from starting. A Guide on How To Deactivate Toyota Immobilizer
4. Operate the horn within 5 seconds of the indicator illuminating. The turn signal lights will flash once to confirm that horn chirp has been enabled/disabled. 5. Turn the ignition switch to 'LOCK' and test the system with the remote controls." "NOTICE. Do not modify, remove or disassemble the engine immobiliser system.
Toyota's Immobilizer can be deactivated by inserting the key, rotating the key, and keeping it in place for 30 seconds, or by putting a Toyota code card into the vehicle's system. Contents What Is An Engine Immobilizer? As part of a Toyota's safety system, the engine immobilizer is critical.
How Do I Bypass Or Disable Immobilizer? As a result, you can bypass the immobilizer by placing the key in the keyhole, which will de-activate the immobilizer so that it can be remotely started. Mobokey has built-in security that allows it to be activated as soon as the phone is removed from the car, eliminating the need for you to worry about
UWP7. 251 303 481 494 285 268 323 393 354

how do i disable toyota immobilizer